Havis C-TSM-CHGR-P-1 Manuel Page 1

Naviguer en ligne ou télécharger Manuel pour Kits de voiture Havis C-TSM-CHGR-P-1. Havis C-TSM-CHGR-P-1 car kit Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 3
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
INSTALL INSTRUCTIONS C-TSM-CHGR-X-1
TRUNK SIDE MOUNT FOR 2011-2013 DODGE CHARGER
X = “D” DRIVERS SIDE OR “P” PASSENGER SIDE
TOOLS REQUIRED:
Phillips Screwdriver
Jig Saw
Powered drill with 5/32” drill bit
HARDWARE:
QTY DESCRIPTION PART #
5 #10 x ¾” Sheet metal screws GSM33195
Always
!
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
C-TSM-CHGR-P-1 shown
Trunk Side Mount
(Passenger Side)
NOTE:
This instruction
shows the passenger side
installation. The Drivers side
will install the same way.
Vue de la page 0
1 2 3

Résumé du contenu

Page 1

INSTALL INSTRUCTIONS C-TSM-CHGR-X-1 TRUNK SIDE MOUNT FOR 2011-2013 DODGE CHARGER X = “D” DRIVERS SIDE OR “P” PASSENGER SIDE TOOLS REQUIRED: Phillip

Page 2 - C-TSM-CHGR-X-1_INST_8-11

C-TSM-CHGR-X-1_INST_8-11 Make sure door has clearance at rear trunk trim panel. With Trunk Side Mount in position, drill three 5/32”” holes into flo

Page 3

C-TSM-CHGR-X-1_INST_8-11 Drill 5/32”holes at upper bracket (next to OEM screw) and attach with # 10 x 3/4” Sheet metal screws Mount and wire equipme

Commentaires sur ces manuels

Pas de commentaire